| 1. | With these links, it is imperative you place the probe at the first physical point where the circuit enters your network.This ensures that you capture actual traffic on the link before it is terminated in the network DSU/CSU. |
| 对于这些链路，你必须把探头放在电路进入网络的第一个物理点，这就确保了在网络DSU/CSU处结束前捕获链路上实际的流量。 |
|
|
| | |
| 2. | The simulated models are compared with the experimental characterization of the injection probe, and the result shows the transmission line model is more identical with actual conditions than the lumped-parameter circuit model. |
| 并将实测的探头参数与两种仿真模型的结果对比,表明分布式传输线模型与实际情况更为吻合。 |
|
|
| | |
| 3. | The circuit can be used to probe the DC current of BA range and can get rid of noise and reduce the drift. |
| 该电路能够检测nA级范围的直流电流并能剔除噪声（特别是低频时在噪声总量中占有优势的噪声）和减少漂移。 |
|
|
| | |
| 4. | PROBE THE CAB GROUND CIRCUIT, CAB CAVITY 1 |
| 探测ＣＡＢ接地电路，ＣＡＢ孔１１。 |
|
|
| | |
| 5. | WITH THE DRB IN OHMMETER MODE, PROBE THE SWITCH SENSE CIRCUIT, CAVITY |
| 使用ＤＲＢ的欧姆档，探测在槽９的开关感知电路。 |
|
|
| | |
| 6. | WITH THE DRB IN OHMMETER MODE, PROBE THE SYSTEM RELAY OUTPUT CIRCUIT. |
| 当ＤＲＢ处于欧姆方式时，检测系统继电器输出电路。 |
|
|
| | |
| 7. | PROBE THE ABS WARNING LAMP DRIVER CIRCUIT. |
| 检测ＡＢＳ警示灯驱动电路。 |
|
|
| | |
| 8. | PROBE THE GROUND CIRCUIT IN CAB CAVITIES 11, 12 AND 2 |
| 探察ＣＡＢ槽１１，１２和２４中的接地电路。 |
|
|
| | |