|
|
| 31. | Test method for shear strength of pressure sensitive adhesive tapes (adhesive layer to back side of the tape) |
| GB/T7754-1987压敏胶粘带剪切强度试验方法(胶面对背面) |
|
|
| | |
| 32. | " Rubber, vulcanized--Method for determination of strength properties of adhesive to metal in shear by tension loading" |
| GB/T13936-1992硫化橡胶与金属粘接拉伸剪切强度测定方法 |
|
|
| | |
| 33. | The designer should consider the influence of construction joints and foundation joints on the shearing strength. |
| 设计人员应该考虑施工缝和地基节理对剪切强度的影响。 |
|
|
| | |
| 34. | shear test |
| 剪切试验 |
|
|
| | |
| 35. | This article introduced the course for solving the key problem of the adhesion strength of the transistor chip for military use in Jinan Semiconductor Institute, and the long-term reliability of the adhesion strength, mainly analysed variety of factors which can effect the adhesion strength. |
| 本文介绍了济南半导体所军用三极管的芯片剪切力的攻关过程及剪切强度的长期可靠性，重分析了影响剪切强度的各种因素。 |
|
|
| | |
| 36. | stationary shearing load |
| 恒定剪切载荷|正常剪切载荷 |
|
|
| | |
| 37. | The result showed that the glued laminated bamboo exhibited excellent properties on horizontal shear strength, MOR and MOE, but the poor performance in an aging test. |
| 结果表明:竹集成材的水平剪切强度、曲强度以及弹性模量等力学性能非常优越,浸渍剥离性能较差。 |
|
|
| | |
| 38. | If the shear strength variable had a value of 0.15, however, the dead regions would be large and the plug would be large. |
| 假如该剪切强度变量为0．15，则停滞区和颈区都要变大。 |
|
|
| | |
| 39. | Test method for in plane shear strength of pultruded glass fiber reinforced plastic rods |
| GB/T13096.3-1991拉挤玻璃纤维增强塑料杆面内剪切强度试验方法 |
|
|
| | |
| 40. | generalized shear |
| 广义剪切 |
|
|
| | |